methogod
09-10-2014, 12:45 PM
Was happening when machine was at 280K on PM, and drums at the 150% (even though they are DU104's and prints looked good) i can tell it was starting to act up...
But to make it through the week i turned off auto registration as prints were still usable.
Did both PM kits - 100K and 200K, and All DV's and even replaced the black DV unit that was at 1.6million (i know shouldnt let it go that far)
Did all the adjustments... Cleared all counters, put the density's back to norm (as machine get past 100% we up the density to compensate)....
And turn Auto Registration back on...
Then later the same day ran 1st job with all new supplies - looks great.
Boom at 650 of 1000 pages (12x18 2 sided) Code trips - machine turns off...
C-4520
1st - if my colors are all good - and shutters open and close in I/O, where do i look next??
2nd - Can someone post or msg all relevant info from MKM on this code...
I do have a spare registration board assembly but i heard its impossible to replace with out go go gadget arms....
thanks,
But to make it through the week i turned off auto registration as prints were still usable.
Did both PM kits - 100K and 200K, and All DV's and even replaced the black DV unit that was at 1.6million (i know shouldnt let it go that far)
Did all the adjustments... Cleared all counters, put the density's back to norm (as machine get past 100% we up the density to compensate)....
And turn Auto Registration back on...
Then later the same day ran 1st job with all new supplies - looks great.
Boom at 650 of 1000 pages (12x18 2 sided) Code trips - machine turns off...
C-4520
1st - if my colors are all good - and shutters open and close in I/O, where do i look next??
2nd - Can someone post or msg all relevant info from MKM on this code...
I do have a spare registration board assembly but i heard its impossible to replace with out go go gadget arms....
thanks,