PDA

View Full Version : Dead Machine C6500 C-5003 and now 6101


Custom Search


jzheld
09-15-2014, 07:35 PM
Machine started fine in the morning after few hours of work it just stopped and I got 5003, started to check all the cables and connectors got 6101, checked the scanner sensor and it is in working order.

Any ideas what else it could be?

laitang
09-16-2014, 01:42 AM
Check 24v output of DC power unit/2 [6]

26425

jzheld
09-16-2014, 04:28 PM
Check 24v output of DC power unit/2 [6]

26425


thank man, i just check it, if I understand correctly the output is on the top of the board? and what is the voltage supposed to be? the 6 points at the bottom of the board, but i can't see any outputs there

jzheld
09-16-2014, 04:50 PM
Check 24v output of DC power unit/2 [6]

26425

Out put one doesn't change after error code comes up
26429
Output 2
26430
Than it changing to this
26431

jzheld
09-16-2014, 07:57 PM
Out put one doesn't change after error code comes up
26429
Output 2
26430
Than it changing to this
26431

so clearly I don't have 24 output

laitang
09-16-2014, 10:50 PM
From DC Power supply 2 CN115 (7pin) to Conveyance drive board CN507 (6pin)
CN115-1 (24V) -> CN507-1
CN115-2 (24V) -> CN507-2
CN115-3 (GND) -> CN507-3
CN115-4 (GND) -> CN507-4

jzheld
09-16-2014, 11:52 PM
From DC Power supply 2 CN115 (7pin) to Conveyance drive board CN507 (6pin)
CN115-1 (24V) -> CN507-1
CN115-2 (24V) -> CN507-2
CN115-3 (GND) -> CN507-3
CN115-4 (GND) -> CN507-4


Thanks man, iI'm getting 1.5V from there, I guess power supply died, or could it be something else?

jzheld
09-17-2014, 11:37 PM
From DC Power supply 2 CN115 (7pin) to Conveyance drive board CN507 (6pin)
CN115-1 (24V) -> CN507-1
CN115-2 (24V) -> CN507-2
CN115-3 (GND) -> CN507-3
CN115-4 (GND) -> CN507-4

Just don't want to get a new board and keep getting an error code. If you have any ideas that it might be something else let me know. I already changed Conveyance drive board, one ICP was bad.

Thank you.

Custom Search