FS-534 jam 72-17

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • sauce_boss
    Technician
    • Oct 2011
    • 26
    #1

    FS-534 jam 72-17

    Getting this jam in all modes staple sort ect. happens maybe once every 50 sheets sometimes more sometimes less. paper is stopping at the receiving roller. Have cleaned all the rollers in the finisher and checked the sensor states. Anyone seen this or something similar.
    Tags: None
    • emujo
      Field Supervisor

      2,500+ Posts
      • Jun 2009
      • 3009
      #2
      Re: FS-534 jam 72-17

      Just ran into similar issue today. If you have a hole punch installed, take a look at the mylars that guide the paper over the punch dies. This one must have been put in after a 4 drink lunch. You cant really see the mylar until you take the black bottom section off (3 #1 Phillips screws). Emujo
      If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.

        Comment

        • sauce_boss
          Technician
          • Oct 2011
          • 26
          #3
          Re: FS-534 jam 72-17

          Thanks for the reply but no punch installed on this one.

            Comment

            • sauce_boss
              Technician
              • Oct 2011
              • 26
              #4
              Re: FS-534 jam 72-17

              This has been resolved finisher entrance sensor was covered in paper dust. Tested good in service mode but would cause the jam intermittenly. Hope it saves someone the time it took me to figure it out.

                Comment

                • fishleg
                  Trusted Tech

                  Site Contributor
                  250+ Posts
                  • Mar 2009
                  • 425
                  #5
                  Thx mate have seen this a few times know what to look for now.

                    Comment

                    • CraigW
                      Trusted Tech

                      Site Contributor
                      250+ Posts
                      • Dec 2010
                      • 417
                      #6
                      Re: FS-534 jam 72-17

                      The mylar on the FS input can tear causing 72-17s, as well as the input sensor mentioned.

                      Thanks to all.

                        Comment

                        Previous template Next
                        Working...