PDA

View Full Version : FS-534 jam 72-17


Custom Search


sauce_boss
09-23-2014, 09:44 PM
Getting this jam in all modes staple sort ect. happens maybe once every 50 sheets sometimes more sometimes less. paper is stopping at the receiving roller. Have cleaned all the rollers in the finisher and checked the sensor states. Anyone seen this or something similar.

emujo
09-23-2014, 11:06 PM
Just ran into similar issue today. If you have a hole punch installed, take a look at the mylars that guide the paper over the punch dies. This one must have been put in after a 4 drink lunch. You cant really see the mylar until you take the black bottom section off (3 #1 Phillips screws). Emujo

sauce_boss
09-24-2014, 12:21 AM
Thanks for the reply but no punch installed on this one.

sauce_boss
09-29-2014, 09:17 PM
This has been resolved finisher entrance sensor was covered in paper dust. Tested good in service mode but would cause the jam intermittenly. Hope it saves someone the time it took me to figure it out.

fishleg
09-30-2014, 03:39 PM
Thx mate have seen this a few times know what to look for now.

CraigW
02-26-2020, 05:04 PM
The mylar on the FS input can tear causing 72-17s, as well as the input sensor mentioned.

Thanks to all.

Custom Search