PDA

View Full Version : C300 ic-406 appears dead


Custom Search


scajjr2
12-12-2014, 03:47 PM
Hi, I started a new job recently and was given the task of hooking a C300 up to be used as a network printer. There is no setting anywhere in admin settings to set an ip address. It appears the ic-406 is dead as no fans are turning and no network led's lit on the lan port. If I disconnect the ic-406 and plug the network cable into the port on the box above the ic-406 those led's are lit so I know the network is ok, but even then no setting to set the ip address shows in the admin settings.

Are there any fuses inside the ic-406 I can check? There is what looks like a breaker push button but nothing happens when I press it. Any common failure points I can look at?

Have been an electro-mechanical field tech for 30 yrs, did a few years as a copier tech (Sharp, Panasonic) in the early 2000's, but have very little experience with Fiery controllers.

Thanks for any help.

Sam
CTM Group

Custom Search