bca
12-12-2014, 07:42 PM
Hi all, this is my first post after many years of finding help on these forums from questions already asked...
I was wondering if anyone would happen to know what adjustments to make on a Konica 7145 that is cutting off the top 1/2 inch or so on prints/copies (the entire image is shifted up, with blank space at the bottom). The fuser assembly and drum were just replaced and I don't think the issue was present beforehand.
I've tried some of the adjustments in 36-mode but I don't know enough about them and they haven't seemed to make much difference.
The worst prints come from the ADF or PC printing, the platen prints are still off but not as much.
Any assistance or direction is greatly appreciated.
I was wondering if anyone would happen to know what adjustments to make on a Konica 7145 that is cutting off the top 1/2 inch or so on prints/copies (the entire image is shifted up, with blank space at the bottom). The fuser assembly and drum were just replaced and I don't think the issue was present beforehand.
I've tried some of the adjustments in 36-mode but I don't know enough about them and they haven't seemed to make much difference.
The worst prints come from the ADF or PC printing, the platen prints are still off but not as much.
Any assistance or direction is greatly appreciated.