View Full Version : C360 flips corner skews image
intermittently flips rear corner over to top running 11" lead edge. swapped fuser and transfer roller/assembly. skews image. tray 2 and LCC. Forget to try 1 was 8.5x11R and OK. TIA
BR549
01-13-2015, 09:36 PM
https://kb.mykonicaminolta.com/img/viewdoc_tab.gif
CAUSE: The registration rollers have a paper guide which can sometimes be a bit tight so that the sheet catches and becomes folded.
https://o.cses.konicaminolta.com/media/CPDocs/C360_folding_corners.png
SOLUTION: Ensure that the lift board of the PC-408 and the trays are correctly adjusted so that the stack is parallel with the bucket. If the problem persists, please use a bizhub C554 Cushion (p/n A161164902) to enlarge the space.
blackcat4866
01-14-2015, 01:49 AM
That was my suggestion. =^..^=
allan
01-14-2015, 05:33 AM
Check the paper guides where the paper exits the tray. The tab on the on side brakes and the guide causes paper to screw.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.