PDA

View Full Version : BizHub 223 help


Custom Search


Elmo
02-12-2015, 12:17 PM
Hi Folks
I have a 223 that i need to clear network settings on
when in admin the network box does not appear but in the top of the screen
it displays waiting for ARP request
i presume it has been set up in the software switches
i do not have a manual for this model can anyone point me at the correct
switch number and value i need to clear this
Thanks in advance

meyu334
02-13-2015, 01:28 PM
try to reset machine to factory deafauls, then try turn DHCP to on and check that machine get ip .. if not then manualy type.
Firmware are latest?

CompyTech
02-13-2015, 01:57 PM
Go into service mode, system 1, initialization and there should be a network data clear.. That should blow out the network settings to factory default without wiping the whole machine.

Elmo
02-17-2015, 08:43 AM
Initializing does not clear it
it needs to be turned off in the software switches
anyone help with the switch and bit number ?

Synaux
02-17-2015, 03:26 PM
when in admin the network box does not appear but in the top of the screen

I am pretty sure there is a NIC reset for this model that is typically bundled with the NVRAM recovery tool.
This will cause the button to reappear in admin mode. I have had this happen a few times with other models.

Elmo
02-17-2015, 03:38 PM
The machine had the hdd removed before we got it
i installed a new one and formatted hdd and ssd
then set machine back loaded animation data
now all working ok

Synaux
02-17-2015, 03:41 PM
The machine had the hdd removed before we got it
i installed a new one and formatted hdd and ssd
then set machine back loaded animation data
now all working ok

Hooray! : )

allan
02-17-2015, 05:04 PM
The machine had the hdd removed before we got it
i installed a new one and formatted hdd and ssd
then set machine back loaded animation data
now all working ok

SSD?

Custom Search