PDA

View Full Version : CQ B601 Background


Custom Search


allan
02-25-2015, 05:02 AM
Hi Guys

I have this one B601 that is giving me a bad background, i have seen this before but was not my problem to fix, that machine ended up scraped so im not sure how to fix this.

Did clear counters.
installed new drum, dev, blade. 600k on the clock
check dev bias connection to be 5 ohm which is good.
check grid voltage to match new drum.
contact springs is all good.
changed charge unit.
check all voltage setting with other machine to make sure it is in same range.
changed the dev unit.

Please look at the sample.
28192
:confused:
Help is very welcome!
Line on the one side is a bad UFR.

allan
02-25-2015, 01:39 PM
Really? nobody seen this?

copier addict
02-25-2015, 01:49 PM
Run 30 to 50 skyshots, run drum peculiarity, that should do it.

allan
02-25-2015, 05:55 PM
Thanks someone gave me the same advice today.

Also to run thru the dipsw to see if there is some tapering. I got the machine secondhand.

The thing is its not over toned. The dev tank work perfectly from the first copy in another machine.

bizhub1
02-25-2015, 10:00 PM
Thanks someone gave me the same advice today.

Also to run thru the dipsw to see if there is some tapering. I got the machine secondhand.

The thing is its not over toned. The dev tank work perfectly from the first copy in another machine.

I just had one do this, and changed softswitches and cleared right up. Changed sw 23-2 and 23-3 from 0 to 1. Also change 5-0 to 1

allan
02-26-2015, 12:28 AM
I just had one do this, and changed softswitches and cleared right up. Changed sw 23-2 and 23-3 from 0 to 1. Also change 5-0 to 1


Thanks i will try those.

tinto89
02-26-2015, 10:37 AM
clean the erase lamp (or replace it)
clean the charge black plate
and run the drum peculiarity adj.

allan
02-26-2015, 05:10 PM
Turn out to be a bad sensor board. I would keep the dip switches in mind Thx.

Custom Search