PDA

View Full Version : 7115 Maintenance Light Err


Custom Search


listsubscriber
03-19-2015, 01:05 PM
I have a Konica 7115 and the maintenance wrench light is on. I have drum, blade, and developer to change for the machine. I checked the count for the PM and it was 32k. Short of the 40k, but copy quality is pretty bad, so we will change it a little early.

I went into service mode, --3, but I can't reset the PM count to get the light to go out. When I hit the button to save the 0 count, I get "Err" on the panel.

We haven't been able to locate anything in the manual for the Err displayed message. Any help you can provide would be greatly appreciated.

Thanks.

Luther
03-19-2015, 03:05 PM
err-incorrect value input, that has to stay at 40k, i think there is a different code for resetting the oil can light..been awhile since ive seen one

Custom Search