listsubscriber
03-19-2015, 01:05 PM
I have a Konica 7115 and the maintenance wrench light is on. I have drum, blade, and developer to change for the machine. I checked the count for the PM and it was 32k. Short of the 40k, but copy quality is pretty bad, so we will change it a little early.
I went into service mode, --3, but I can't reset the PM count to get the light to go out. When I hit the button to save the 0 count, I get "Err" on the panel.
We haven't been able to locate anything in the manual for the Err displayed message. Any help you can provide would be greatly appreciated.
Thanks.
I went into service mode, --3, but I can't reset the PM count to get the light to go out. When I hit the button to save the 0 count, I get "Err" on the panel.
We haven't been able to locate anything in the manual for the Err displayed message. Any help you can provide would be greatly appreciated.
Thanks.