Blank copies after fuser error
Blank copies after fuser error
What have you checked so far? Prints are good?
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
fuser error message is what exactly??
Error Code 6A. The error dis appear after replacing the Center thermistor...But the machine is gives Blank copies
This is what I've found in the service manual: "Electric discharge that may be caused by dirt on the corona wire of the drum unit was detected." So yeah, not quite helpful
That's odd usually you don't really interfere with anything delicate during a fuser swap/repair - (few screws in the rear area). If you force a print to stp (opening a cover) you can check if there's any image on the drums/transfer. Are you shure the unit was OK before the fuser error?
Copies are fine before the error. I think the problem is with the image processing because if i move the charger cleaner to the center , there will be a solid black line on the copy.
Bookmarks