problem IRCADV 5235

[Joseph2011]

Goodnight
I have a problem with a machine canon IRCADV 5235 tries to start and the bar that comes out in the bottom of the panel is advanced a bit and the machine restarts itself several times and never gets ready, I tried to reinstall the operating system but, for the same thing that reboots alone has left the code E602-0001 and is inoperative, another partner has also reported that the equipment he has been working normally and now the screen remains black and only turns on the green led and no engine works only the fans of the main cards, please your help


thank you very much

[JPiek]

E602 0001 00 : Error in HDD

HDD failed to be recognized. Startup partition (BOOTDEV)
failed to be found at startup.

1. Turn OFF the main switch and check connection of
HDD cable, and then turn ON the main switch.

2. If the Encryption Board has been installed, there may
be an Encryption Board failure. In this case, disconnect
the signal cable connecting to the Encryption Board and
directly connect to the HDD. (It cannot be connected
from the back side. Open the Main Controller Cover, and
connect by going over the Main Controller PCB 1.) After
connecting, power on by the safe mode. If the machine
starts normally, replace the Encryption Board as the
Encryption Board had failed.

3. Be sure that HDD spins stably (no problem in drive
sound) and 5V/12V power is supplied when the main
power is turned ON. (If the drive sound is abnormal,
replace the HDD.)

4. Replace the HDD and reinstall the system. (In the case
of using a USB memory device, insert a USB memory
device where the system software has been registered to
the slot of the host machine, and then execute main menu
[3]: Upgrade (Overwrite all).)

5. Replace the Main Controller PCB 1.

[tech28]

Had one do that about a month ago, had a parts 5235, took HDD out of that one and installed in troubled Canon, and machine fired right up and has had no issues since then.