Quote Originally Posted by Kwaku01 View Post
Is there some where I can disconnect and connect again. It's worth a try...it was working fine this afternoon.
ok you say you have service manual... -= IF =- you want to try pull/connect wire harnesses back let me give you a few bits of advise...

1) TAKE PHOTOS of all side of that board BEFORE pulling even one harness

2) take a Sharpie and mark ALL open connectors on the board

3) be VERY CAREFUL when pulling/reinstalling the FCC's (flat cable connections) if you bugger one of the lans on the cable you are SCREWED. Some have black slides that lock the cable in place... MAKE SURE you insert the cable STRAIGHT into the connector.

4) get an anti-static wrist band and hook it to the METAL FRAME of the unit and to your wrist... I also touch the frame any time I shift my body ( static ) or moving to push harness out of the way. ( boards are HIGH $$$ and can be damaged due to static electricity VERY EASILY!!

good luck..take it slow...measure twice, cut once.