i am from thailand
my ir2535i it japan spec ADF run only LTR when i put A4 can print only LTR area.
thank you
i am from thailand
my ir2535i it japan spec ADF run only LTR when i put A4 can print only LTR area.
thank you
____________
Service Mode>SCAN>SCAN READER>OPTION>BODY>SENS CNF = 1
Power cycle machine.
To make the value of SENS-CNF stick after the Copier is rebooted, the following needs to be set in service mode.
SCAN > SCAN SW > SW06 > Bit2 to 1
Also, to enable the correct paper selection, change the following setting of the paper size
group.
SYSTEM > SYSTEM Numeric > 057 to 3 for inch configuration
Or in your case, select #1 for AB
1: AB configuration
2: A configuration
3: Inch configuration
4: AB / Inch configuration
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Dear teckat I try step by step but not work. may i do something mis or my MC damage.
Service Mode>SCAN>SCAN READER>OPTION>BODY>SENS CNF = 1
Power cycle machine.
To make the value of SENS-CNF stick after the Copier is rebooted, the following needs to be set in service mode.
SCAN > SCAN SW > SW06 > Bit2 to 1
Also, to enable the correct paper selection, change the following setting of the paper size
group.
SYSTEM > SYSTEM Numeric > 057 to 3 for inch configuration
Or in your case, select #1 for AB
1: AB configuration
2: A configuration
3: Inch configuration
4: AB / Inch configuration[/QUOTE]
Damaged
every body
Please advice.
need help.
Related Service Mode:
• Select the following service mode to determine whether to detect the original size:
SCAN > READER > OPTION > USER > SIZE-DET
<Setting value>
0: The original size is not detected.
1: The original size is detected.
• Perform the following procedure to switch between AB and inch configuration.
1. SCAN > SCAN SW > SW06 > Bit2
Set the value to 1 about the above service mode, and then turn the power switch to off
and then on.
2. SCAN > READER > OPTION > BODY > SENS-CNF
<Setting value>
0: AB configuration
1: Inch configuration
2: A configuration
To enable the correct paper selection, change the following setting of the paper size
group if necessary.
3. SYSTEM > SYSTEM Numeric > 057
<Setting value>
1: AB configuration
2: A configuration
3: Inch configuration
4: AB / Inch configuration
SCAN SW.jpg
■■FEEDER
●●(#SCAN> FEEDER> ADJUST> DOCST)
Adjusting the original stop position for ADF pickup (original tray pickup).
Delivering the original enables the setting. Be sure to press the OK key to deliver the original.
When changing the setting, input the setting on the main station service label.
The larger the value, the smaller the leading edge margin.
●●(#SCAN> FEEDER> ADJUST> LA-SPEED)
Adjusting the original feeding speed in stream reading.
Use this mode to adjust the original feeding speed in stream reading mode.
The larger the setting, the faster the speed (the image reduced).
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks