Hi, anyone had counter this problem? the printing got some bold/jerking font when printing,intermittent only... not continuosly. can check sample print below as attached document. i do really appreciate if any can helps me.
Hi, anyone had counter this problem? the printing got some bold/jerking font when printing,intermittent only... not continuosly. can check sample print below as attached document. i do really appreciate if any can helps me.
I can't tell you exactly what's causing it, but that's a compression blur. The paper was traveling slower than the image on the drum.
Several things can cause this:
The paper may be slipping against the registration rollers.
You may be losing drive to registration rollers
More likely the fuser is turning slightly slower, buckling the paper away from the drum as the trail edge is released from the registration rollers.
So that gives you three things to look at. Start with the last one. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Like BC said, check the last one. I would start with trying different paper formats and with trying to change paper settings to thick one, this will reduce processing speed and eventually match speed. If fine adjustments of Fuser speed is available on this model I will give them a try also.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
That looks like it would be lead edge. Don’t rule out transfer/drum area. Make sure drum screw is tight. Just had one loosen up on that model a few days ago. Don’t remember the quality issue but it eventually went blank. Transfer belt can shift dramatically when it gets old and stretched. Registration clutch? Is the registration varying at all? Any burrs or toner crust in fuser entrance?
Sent from my iPad using Tapatalk
Solved the problem, registration roller problem.. to slippery. Thanks guys for your help.
Bookmarks