Hello!
We have a Canon ImagePress C6000 VP that has registration problems after we changed an M image drum.
ITB looks good and we haven't had any problems before with the registration.
Anyone have any idea what it might be?
Regards
LAKA
Hello!
We have a Canon ImagePress C6000 VP that has registration problems after we changed an M image drum.
ITB looks good and we haven't had any problems before with the registration.
Anyone have any idea what it might be?
Regards
LAKA
In service mode run Copier>Function>Misc-P>AT-IMG-X this runs a series of image position correction adjustments
Hello!
We have tried this and the result is a "NG" message.
This could indicate that ITB is bad, but we are pretty sure that is not the case!
HI
It seems that the registration is skewed on paper (see picture)
It is ok on one side.
How to adjust it?
Regards
LAKA
2020-05-06 11.05.28.jpg
Hate to say this but it is likely your ITB. had an c8000 do this with yellow being the problem color, the belt only had 200 k on it but had weird wear patterns where the patch sensors were reading the patches.
Hi!
Now I have tried an old ITB that we changed a year ago (it worked then, but has small white dots).
Exactly the same problem with registration with this ITB! ( see attached picture)
Must be something else !?
Regards
LAKA
2020-05-07 15.35.50-1.jpg
you said this all started when you changed the magenta drum, I am guessing you have double checked your work (self inflected wounds are the worst) have you tried swapping laser units ?
Hey ! well, it may well happen that someone does wrong ... sometime.
I'll double check on this after the weekend again ...
Regards
LAKA
It's also light on the one side...did you do itb-init? Patch reader clean? External secondary roll ok?I've had bad lasers do this on irac 5000s, 5200s,etc. Pop the old drum back in for starters...
Bookmarks