Here's an update for anyone interested. After re-seating all the connectors on the motor board with no luck, I went back to, it had to be a setting but could not find it under common settings so I went back into the service mode and under copier>options>cst>p-sz-c1 and c2 the setting was 38 but the range said it should be between 6-1 Changing it to 18 and everything is fine and tray 1&2 say LTR now. It must have got a spike or something because it's been well over a month since I was there so I know I didn't change it. I knew all along it was something stupid since the machine functioned normally except for those two trays.
Glad you found it. That’s what I was thinking when I asked what size the trays were reading under paper select. Manual helps since a lot of us don’t see too many of that model anymore
Sent from my iPhone using Tapatalk
I’ve seen it.
Sent from my iPhone using Tapatalk
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Bookmarks