Canon iRA5535 Touch Calibration

[ldharnden]

First off I ALREADY KNOW HOW TO RUN THE NORMAL CALIBRATION IN SERVICE MODE!

Ok, that out of the way. I replaced the CPU board for the panel. It now works correctly but is about an inch off calibration which won't let me select things to get to the calibration area in service. I remember using an alternate recovery method which was found in e-support, but with Canon having issues I can't get to the knowledge base article.

Does anyone remember the alternate way to get to the calibration screen? Thanks.

[MunsterTech]

For iRADV models:
If the coordinate on the Touch Panel is out of alignment, it may not be possible to access this mode by the usual method. In that case, the Touch Panel can be adjusted by performing the following menu operation using hardware keys.
• Press [5] key 3 times on the service mode top screen. Note, this does not always work on older edition devices.
Service Bulletin
HARDWARE
Issued by Canon Europe