I have problem when I do test 10 that black bar is shorter than the others.
How to solve it. Thanks to every reply.
Untitled.jpg
I have problem when I do test 10 that black bar is shorter than the others.
How to solve it. Thanks to every reply.
Untitled.jpg
Your registration is way off, check the operation of your patch sensor shutter / patch sensor. the shutter has a little nipple that can break off so when the solenoid gets activated the shutter doesnt move or moves partially.
I have solved it by cutting the clamps that hold the signal cables to the laser driver.
cut all the clamps under the drum/developer, around laser connector (side operator).
"Knowledge is a source, but unfortunately ignorance is a sea."
Black drum may not be sitting properly. Take apart the laser units and clean mirrors and lens, reassemble, clean patch sensors and run color mismatch. Then do auto grad and see if aligned. Can be adjusted in service mode if still misaligned.
IBM, Mita, Konica Minolta, Ricoh, Kyocera, HyPAS, Canon, Oce, Samsung, HP, TEO IP PBX/Unified Communications, Comptia Network+ Comptia PDI+ Certifications
Regards Mark
FOR TRADE AND END USER SERVICE CALLS PLEASE VISIT WEB SITE FOR CONTACT DETAILS. COVERING GREATER LONDON {UK} AND ALL SURROUNDING COUNTIES.
RICOH, CANON, KYOCERA, KONICA, SHARP, HP/SAMSUNG BROTHER, LEXMARK.
https://copierservices.simdif.com
Bookmarks