Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    Trusted Tech 50+ Posts markdmt's Avatar
    Join Date
    Dec 2009
    Location
    north salt lake, utah
    Posts
    66
    Rep Power
    23

    ImagePress C700 C800

    I am getting a delay jam 0107 only from the deck. any ideas. I have cleaned all of the rollers and checked the sensors. this is a new install so maybe something go bumped during travel. Also, does anyone have a parts list for the upper Buffer feed unit ay? it is part of the Kit-A1 used to connect the pod deck?
    I have parts lists for the main unit and the pod deck but can seem to find the Upper and lower buffer. I am still getting used to this printer but I think it will be much more reliable and easier to work on than the old IPC 6000VPs. thanks for any help provided.

    ok, I think we are narrowing this down. the upper baffle on the top entrance to the registration assembly moves up and down to engage the nip rollers. I assume it moves up and down during its home cycle then, it seems possessed when it goes to print. It will move up and down then about the time it is supposed to feed it intermittently moves up off of the drive rolls and I think the upper buffer feed unit is trying to push the paper past into the registration unit but there isn't any drive if those wheels are up. This is causing the upper buffer feed unit to chatter while it is driving the sheet through. When we run from the other trays it likely isn't affecting it as much because the other rollers in the lower entrance to the registration are driving the sheet through that area. When that baffle stays down in the correct spot it runs smoothly without and chattering. Has anyone seen this issue and have suggestions on how to fix it?
    Last edited by markdmt; 1 Week Ago at 12:27 AM.

  2. #2
    Service Manager 1,000+ Posts
    ImagePress C700 C800

    charm5496's Avatar
    Join Date
    Apr 2008
    Posts
    2,381
    Rep Power
    56

    Re: ImagePress C700 C800

    Is this a new setup? There are guide plates that need to be moved depending on the model. This is detailed in the setup instructions.
    Accidents don't just happen. They must be carelessly planned.

  3. #3
    Junior Member
    Join Date
    Dec 2020
    Location
    Beirut
    Posts
    9
    Rep Power
    0

    Re: ImagePress C700 C800

    Hello ,
    Just like what charm have said there is a guide metal plate at the inlet of the engine , you should only loosen the screw from the front side and shift the plate and then tighten the screw.

    Some sheets have a hard curvature and it hits while entering the engine and causing the jam.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here