Ir advance 6075 error code E 00067-00001,replaced almost probable pcb's and devoloping unit no result any idea?
Ir advance 6075 error code E 00067-00001,replaced almost probable pcb's and devoloping unit no result any idea?
Has the torsion spring come off the buffer assy?
When you think you have made a procedure idiot proof your company employs a better idiot.
- Code: E067-0001
- Description: Developing high voltage output leak error
The leak detection signal was detected 5 times in a row for every 20 msec.- Remedy: 1. Check the connection between the Main Driver PCB (PCB2) and the High Voltage Unit. Main Driver side: J112, High Voltage Unit side: J3098 2. Check the connection between the Relay PCB (PCB5) and the High Voltage Unit. Relay side: J519, High Voltage Unit side: J3099 3. Replace the Developing Assembly. 4. Check the connection point of the Developing Assembly. If it is soiled, clean it. 5. Check the connection inside of the High Voltage Unit. Check the connection of the High Voltage Unit Relay (J3097) and the Developing High Voltage PCB (J3511). High Voltage Unit Relay (J3099) and Pre-transfer Charging PCB (J3545, J3500, J3510) 6. Replace the Main Driver PCB (PCB2).
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Did you check to see if the pre-transfer wire was broken?
Sent from my iPhone using Tapatalk
Bookmarks