Hi all,
Quick question what are the differences between these models please?
Hi all,
Quick question what are the differences between these models please?
Last edited by copier tech; 05-11-2021 at 09:28 PM.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Different type of connectors.
Some electrical boards PCB different.
On the touch screen there is the Timeline column on the right.
Some strandard functions:
- Web Browser - Encrypted Secure Print - Secure Watermark - Encrypted PDF+Device signature PDF
SIEM / SYSLOG
SECURE BOOT during the start up
McAfee Embedded Control
Different System Software (I & III edition)
With the introduction of the 3 edition models, the service modes for changing the thresholds of the level of toner level.
Previously, the service modes COPIER>OPTION>FNC-SW->T-DLV-X and COPIER>OPTION>DSPLY-SW->T-DLV-X were used to change the toner level.
COPIER>OPTION>DSPLY-SW->T-LW-X) on a percentage that indicated that when the XX % of remaining quantity of toner, now with these new machines we go from a percentage to a number of days.
Last edited by giogi; 05-12-2021 at 01:13 PM.
"Knowledge is a source, but unfortunately ignorance is a sea."
Thank you for this info much appreciated.
I have a few C256i with failing ITB units after replacing them I tried to update the firmware as per the bulletin however I couldn't get this to load so was wondering of i'm trying to load the wrong type. On the counter print it does not say if the machine is a gen 3 etc it just shows the model as a C256i.
Measure against lines caused by ITB.pdf
Last edited by copier tech; 05-13-2021 at 07:57 AM.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
For the III edition on the front door near the model is printed a symbol "III".
the system of 256 is different from the system of 256 III ed.
"Knowledge is a source, but unfortunately ignorance is a sea."
Transfer belts dont hold up very well on these desktop models. Its an expensive machine to maintain. Better charge about .04 cents per copy and .10 for color. Lost my ass selling this model a few times. Ive also seen the main board blow out after a few years. Its a junk model.
Update via CDS.You can't miss.
On this model i change itb many times in a short timeAlso main controller is not ok.
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
Bookmarks