IRADv6055 jamming every time J0113

[copier tech]

Because they use stepper motors now instead of clutches, when the bushings in the delivery assembly get gummed up, the load causes the stepper motor for the delivery drive to stall(old DC motors never stalled..ran all the time, Dcon turned clutches on and off for operation usually). As mentioned, do the mod and get rid of the bushings in the delivery assembly. Bearings will take the load off and you probably won't need to replace the delivery drive assembly. It sucks changing the delivery drive..big time..I've done a few

Great explanation this makes perfect sense.

So, as a quick test applying spray oil to these bushing should, in theory, temporarily resolve this issue?

[Hishamawada]

i prefer you clean the whole turn unit as i mentioned above then put some oil

Sent from my SM-G610F using Tapatalk

[Canuck]

Yes oiling will loosen them up enough to verify issue but these are Oilite bushings are are not meant to be oiled. If you oil them, it mixes with paper fibers,toner etc and seize again. Oiling gets rid of the symptoms..bearings will eliminate the problem. 62xx/82xx come with bearings already in them

[copytech,mike]

Because they use stepper motors now instead of clutches, when the bushings in the delivery assembly get gummed up, the load causes the stepper motor for the delivery drive to stall(old DC motors never stalled..ran all the time, Dcon turned clutches on and off for operation usually). As mentioned, do the mod and get rid of the bushings in the delivery assembly. Bearings will take the load off and you probably won't need to replace the delivery drive assembly. It sucks changing the delivery drive..big time..I've done a few

Makes sense. Fewer clutches is a good thing.

[copytech,mike]

Yes oiling will loosen them up enough to verify issue but these are Oilite bushings are are not meant to be oiled. If you oil them, it mixes with paper fibers,toner etc and seize again. Oiling gets rid of the symptoms..bearings will eliminate the problem. 62xx/82xx come with bearings already in them

Ive had good luck with a drop of tri-flow on those oilite bushings and i normally try to take things apart if i can to clean the shaft and bushings ect. I will keep your info in mind. Drive units getting gummed up.

[copier tech]

Ive had good luck with a drop of tri-flow on those oilite bushings and i normally try to take things apart if i can to clean the shaft and bushings ect. I will keep your info in mind. Drive units getting gummed up.

This is my thought, machine has done 1.7 million if a few drops of oil can get say 200k by then we'll put a new machine in this site.