Installation of ImagePass B1 on Canon C5030i

[acomp]

Hi,

I'm trying to install an ImagePass B1 controller on a canon C5030i. So I installed the interface board in the copier, connected the EFI controller to the copier and changed the IMG-CONT to "3". As I start up the copier, the display on the rear of the ImagePass shows "00". Now my question: How can I access the ImagePass? Is there a special menu for it? How can I assign an IP Address to the ImagePass? The standard IP v4 settings have disappeared in the canon setup options since I set up the ImagePass.

[zoraldinho]

Capture.jpg

[acomp]

Thanks a lot! That was the thing I was looking for. Works perfect now.

[acomp]

Thank you for the advice. I already had installed the crossover cable but didn't know how to configure the RIP.

[zoraldinho]

Thanks a lot! That was the thing I was looking for. Works perfect now.

No problem.