I have a canon C7570i III with an error code E000029-1000. I did a hard reset on the unit and after the reboot that came up. Any advise would be greatly appreciated.
I have a canon C7570i III with an error code E000029-1000. I did a hard reset on the unit and after the reboot that came up. Any advise would be greatly appreciated.
Why did you perform a 'hard reset?' It sounds like the patch sensor is dirty, clean it.
- Code: E029-1000-05
- Description:Patch Sensor error
- Causes:The Patch Sensor detected correction error of the light intensity value determined at initialization.
- Remedy:[Related parts] R1.00 - Harness between the Multi Driver PCB (UN97/J1353) and the Patch Sensor (PS21/J7412) - Patch Sensor (PS21) - Multi Driver PCB (UN97) [Remedy] Perform the following in the order while checking whether the error is cleared. 1. If the sensor surface of the Patch Sensor is soiled, clean it with a cloth tightly wrung out of water. 2. Check/replace the related harness/cable, connector and parts. 3 Update system software
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Bookmarks