Canon IR adv 4235i Jams in fuser

[sly]

Have a 4235i with jam code 0107. Paper from all draws along manual feed jam at same place in fuser ass when copying single sided. I have fitted a new fuser ass which normally resolves jams with this code in my experience.
any thoughts please would help.

[nicknt82]

Paper pass throught Fixing delay

Check any worn at leading edge paper
Maybe 2 reason: pressure between Pressure Roller and Fixing Film not good, or Flag of Fixing outlet sensor got sticky then it's operation not correct

[sly]

Thanks for reply. The jams are occurring with a new fused unit not just a film replacement. Will take a look at your suggestions when I visit in the next few days. Thanks for your input.

[nicknt82]

If replace with good Fixing assembly still jam then problem will be at Registration Sensor or Flag of registration sensor

[sly]

Thanks Nick, have you ever had issues with the light type registration sensor. I have had issues with the old flag type with the damper pad getting sticky, thought the new reflector type fitted to the 42 series are reliable as I have had no issues except cleaning them ? Worth a look. Thanks.

[Venom]

Also look for toner blobs on paper guides, had one same issue.

[mramlawi]

Is the jam code 107 .feed us with the jam code plz

[sly]

Did mention the Jam code 0107 on the 0riginal thread.

[soria]

I will now exchange the corresponding unit with sensors and coils.

[apoxi]

Have a 4235i with jam code 0107. Paper from all draws along manual feed jam at same place in fuser ass when copying single sided. I have fitted a new fuser ass which normally resolves jams with this code in my experience.
any thoughts please would help.

Hei,

I have this problem too. I have ADV4525i III (3rd generation)

Jam 0107 - the fixing unit was replaced with NEW one (ORIGINAL)!!!!

The jam steel occurs.......