Likes:
0
Dislikes:
0
-
Junior Member
- Rep Power
- 0
Canon ir adv c5500 series, error when switching document feeder from c5535 to c5540
Hello,
Has anyone come across the issue of when you take a single pass document feeder from a Canon IR ADV C5535 and install it on a C5540, the copier will not accept that document feeder and give an error code? Is there some form of value setting within the service mode that needs to be adjusted for the copier to recognize the document feeder? I would think that the document feeder for the C5500 series should be interchangeable within its series as long as it's the same type of feeder.
-
Re: Canon ir adv c5500 series, error when switching document feeder from c5535 to c55
What error code are you getting? It may be just a firmware mismatch.
-
Trusted Tech
50+ Posts
- Rep Power
- 10
Re: Canon ir adv c5500 series, error when switching document feeder from c5535 to c55
Firmware update.
It's important make sure the generation is the same; they swapped PCB boards between some of the generations.
You may just be able to change swap the board in the doc feeder -if the previous issue wasn't electrical.
-
Technician
- Rep Power
- 1
Re: Canon ir adv c5500 series, error when switching document feeder from c5535 to c55
Your fault is that the FLASH electronic hard drive data is damaged, resulting in an incorrect body number. It should be an error code E355-001 or E350. The error still exists when you reinstall it.
If you want to solve this problem, you need a tool to rewrite the correct machine serial number data of IRC5540, otherwise you cannot repair the machine, causing damage to two machines.
I am a Canon technician and I am very responsible for telling you this question. If you have any questions, please continue to chat.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks