Getting black streaks after 300 copies or so. Replaced developer roller and doc blade/all coronas/drum cl. Blade and fuser but can't get rid of these black streaks. It happens in print and copy modes. Help appreciated thanks t.
Getting black streaks after 300 copies or so. Replaced developer roller and doc blade/all coronas/drum cl. Blade and fuser but can't get rid of these black streaks. It happens in print and copy modes. Help appreciated thanks t.
I would try thoroughly cleaning or replacing the ozone filters.They clog up way before life and can cause some very weird cq issues as the ozone levels build up in the drum area.Otherwise,it only leaves the drum which is much more expensive.
Good luck, Mark.
screwtape what is ap kit and the drum has 250k on it replaced 2 months ago. i replaced the cws and have the units on order.
thanks
I would replace the recipricating arm on the ap kit before i replaced the whole assy.The disk on the front of the ap kit makes the cleaning blade move back and forth.If it doesnt,then toner starts to build up and will start to slide by the blade.
hey guys is the ap kit or parts in the ap kit the same as the 550. thanks t
AP kit FG6-8724-0000
ARM FB6-2400-000
I would replace the reciprocating arm and the disk it rides on. But you can also check the blade backing. If it has a ding in it that will cause poor contact and can also affect the way the blade sits. It is just a thin piece of sheet metal and we have actually removed them and it will not cause any issues that we have seen. We have taken them out of numerous machines without problems. I would also make sure it is not being caused by the fixing assembly. worn press roller bearings, web not moving, worn heat roller can all cause black lines.
Bookmarks