**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Você verificou ou substituiu o ITB? [/ QUOTE]
Sim,ja foi substituído, tenho outra maquina aqui.
Quando substituí o cilindro por um novo essa falha havia desaparecido, mas depois de umas 100 impressões retornou.
Substituí tambem as unidades reveladoras, placas hvt, dc controller, sensor de potencial do cilindro, todos sem resultado.
ps test.jpg
Does the issue stay in same place ????
O problema fica no mesmo lugar?
-------------------------------------------------
what cylinder did u replace ??
--------------------
Que cilindro você substituiu?
----------------------------------------------------------
you need to remove all developer cylinders / and inspect turret with a flashlight for any dirt,
and you need to clean inside that turret on all changes.
-------------------------------------------------
você precisa remover todos os cilindros do desenvolvedor / e inspecionar a torreta com uma lanterna para qualquer sujeira,
e você precisa limpar dentro dessa torre em todas as mudanças.
Last edited by teckat; 09-21-2017 at 07:33 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
[QUOTE = teckat; 577723]
O problema fica no mesmo lugar ????
O problema fica no mesmo lugar?
------------------------------------------------- o
NÃO FICA NO MESMO LUGAR
que cilindro você substituiu?
IMAGE DRUM
[/CITAR]
then you need to remove all developer cylinders / and inspect developing rotary turret with a flashlight for any dirt,
and you need to clean inside that ROTARY on all changes.
-------------------------------------------------
Last edited by teckat; 09-28-2017 at 03:27 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Boa tarde Sr. Teckat, fiz os procedimentos a que me instruiu, mas sem resultados.
Porém quando desligo PO_CNT para 0, não apresenta o problema.
Muito obrigado pela disposição em me ajudar.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Controle de Potencial foi desligado para teste mesmo.
DC Controler PCB e Sensor de Potencial também já foram substituídos, porém sem resultados.
Check that the Developer Unit Fixed Arms (plastic arms on either side of the Developing Unit that screw down to hold the unit in place) are screwed down securely.
Image shown > these lines are in Paper Feed Direction
what shows on single color PG 5 test prints
do lines move down paper on continuous prints
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
IMG_20171010_173031173_HDR.jpgIMG_20171010_173743446_HDR.jpgimpressões em formato a4.
A foto anterior estava em a4-r.
Bookmarks