**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Well, I think I had it wrong with the standby light it's suppose to be the power ON light instead. sorry for the wrong information the machine don't even start for you to do the post procedure. The power light comes ON on the panel and that's the only thing you see when the unit is switched ON.
I tried the ir3235 main board on the ir3225 machine it behaved the same way only the power ON light comes on. But as i told you i'm yet to tried the ir3225 main board on the ir3235 machine to confirm my trouble shooting on the faulty copier.Hope you will forgive me for the wrong info given earlier
Thanks.
reagards hope to hear from you soon.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
I used the memory of the ir3225 for that but didn't boot. the ON light just stays on and nothings moves no sound at all.
thanks
I used the memory of the ir3225 for that but didn't boot. the ON light just stays on and nothings moves no sound at all.
thanks
I will swap the display panels for us to see the out come.
thanks
Dear oh dear. Seems quite serious. Might sound silly but have you tried unplugging the hard drive. Seems wierd that you get nothing. No boot would indicate something with connection to the boot rom. There is a UFO for this model which states that the machine will not boot. And it instructs you to replace the main controller pcb to resolve it. But as mentioned by teckat you have to get the right main controller that particular model. Good Luck!
My bad main controller symptoms were exactly the same, green light on, the only indication that the copier was plugged in and turned on. Nothing followed the switching on except the green light. I tried the shorting of the pins, no change, I verified the all night power supply was providing the 3 volts to the main controller. No motors, no fans, no nuttin'...
After the main controller gets the 3 volts established, it sends a signal out to the low voltage power supply to send voltages out to the rest of the copier. No signal sent out to the power supplies creates the dead machine...
Bookmarks