e602-0003 is a Write-abort error on HD sector
PDL-related file storage area
Stores font data for printers
always follow your shut down procedure from control panel if available > tell customers to never just flip the side power switch/ especially if network jobs are spooling
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
read this...
Learning never ends..
Never give up, where there is a wheel there is a way..
u list two different error codes ????
E064 Error Code
Check the setting of COPIER>ADJUST>DEVELOP>DE-DC in service mode. Compare this value with that of the service label. If the setting is found to be out of adjustment, set the value back to door specifications. After making the adjustments, run some continuous copies to check for occurrence of the code. Since this value is maintained by the DCON the same adjustment is required after replacement of the DC controller.
make sure u have an updated (POWER SUPPLY)Switching Regulator
(01) =Old Switching Regulator PCB
(02) =New Switching Regulator PCB
POWER SUPPLY.JPG
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Hello Sir,
When i scan more than 4 pages then getting erroe E000602-003 plz. tell me the solution for this problem.
-----------------
e602-0003 is a Write-abort error on HD sector
PDL-related file storage area
Stores font data for printers
always follow your shut down procedure from control panel if available > tell customers to never just flip the side power switch/ especially if network jobs are spooling
FIRST
try a defrag of HD/
Try this HD CHECK>
Power off printer hold down the '1' and '9' keys on the keypad >while holding down keys >power up printer with other hand >hold until you see a flashing white block , it will show in the top left corner of the LCD.
Normally, 'HD-Check' lasts about 15-20 minutes, and ends if no fault is encountered or specific sectors have automatically been repaired bringing up DOWNLOAD MODE on the LCD.
DO NOT STOP ONCE STARTED.In certain cases,"HD-Check" can take longer than 15-20 minutes and sometimes the machine can hang in this mode and will never complete.
if this does not work-u need a new HDD
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks