my canon IRC 3220 problem is machine sometimes panel blank when print and no copy come out. when i switch off and on machine again sometime ok. but after use it again same problem will appear.. can i know which parts have a problem?
my canon IRC 3220 problem is machine sometimes panel blank when print and no copy come out. when i switch off and on machine again sometime ok. but after use it again same problem will appear.. can i know which parts have a problem?
thnks for the info
Hi Teckat, I also facing the same problem and I have done the step you mantion above, replaced the distribution pcb and the machine still the same, Am I need to replace the Memory Ram?
thanks
Hello , i know this threat is an older one but i have the same issue.. i have already reseat the Ram but still same issue.. any new information about this? thanks Michael
My profile is not working at the moment. The profile you see is not mine. Board redirects to a wrong userprofile. So you CANīT REACH ME over the profile via SEND PRIVATE MESSAGE and even not over regular Email too
You only can contact me if you click my name on a post and select PRIVATE MESSAGE straight from there.
hm... where are all the canon technicians? it would be really nice to get help... thanks michael
My profile is not working at the moment. The profile you see is not mine. Board redirects to a wrong userprofile. So you CANīT REACH ME over the profile via SEND PRIVATE MESSAGE and even not over regular Email too
You only can contact me if you click my name on a post and select PRIVATE MESSAGE straight from there.
hello, at some point it seems to me that I had that problem, in one machine the problem was in the accessory connectors (paper feed trays and the adf) in that connection set associated with the duplex motor, I chose to disable the duplex.
Blank screen is also related to the main mainboard, RAM or SDRAM memory of the mainboard.
Regards.
Hello, did you clean the main controller assembly, clean memory and sub pcbs boards (hdd, scan, print, etc) with a white eraser.
regards
Hello, i reseat the memory, cards , reconnect hdd. The panel goes not off but went to orange red without any information on it. This is not always at same time or same job.
My profile is not working at the moment. The profile you see is not mine. Board redirects to a wrong userprofile. So you CANīT REACH ME over the profile via SEND PRIVATE MESSAGE and even not over regular Email too
You only can contact me if you click my name on a post and select PRIVATE MESSAGE straight from there.
Have these got a screen contrast dial, maybe it's a problem with that pcb.
When you think you have made a procedure idiot proof your company employs a better idiot.
Bookmarks