IR 2520 heater problem

[mido]

Hi,
I have a prolbem in Canon IR2520, the toner not fixed on the paper it erased when wipe by finger,
the counter of the machine is about 10.000 copies, the fixing film unit is new and original by canon.
I want your opinion about this problem

[tieuquyen]

Hi,
I have a prolbem in Canon IR2520, the toner not fixed on the paper it erased when wipe by finger,
the counter of the machine is about 10.000 copies, the fixing film unit is new and original by canon.
I want your opinion about this problem

Did you use OEM toner?

[mido]

Did you use OEM toner?

I used original toner

[zoraldinho]

What tipe of paper do you have? Change paper tipe to heavy and check again.Try with different paper.Can be bad termistor or DC controller.
Inspect fixing temperature!

Related Service Mode

Offset of fixing control temperature (High and low of control temperature)
PRINT > SW
> 62 (Control temperature during cassette feeding)
> 63 (Control temperature in Heavy/Heavy-H/Bond paper modes)
> 166 (Control temperature for the second side of 2-sided copying)
> 173 (Control temperature for the second side of 2-sided copying)
> 179 (Control temperature in Postcard/S-Postcard/Envelope modes)


<Setting value>

0 to 2: +15 deg C
3 to 11: +12 to -15 deg C (each 3 deg C) [Default: 7]
12 to 14: -15 deg C

[Rachid.Akli]

Hello,

Have you replaced the film because of E0007 error code or because of the same toner fixing issue that you've now?

A toner fixing issue may occur because of:

1- Toner is faulty: It's not your case (you're using canon toner).

2- The fixing temperature is not high enough. verify it in display mode.

3- The fixing pressure is not good.

Good luck.

Rachid.

[arielcanon]

if u use oem toner, try replacing fixing unit...

[good]

I have a similar problem before. I just changed my generic toner to a OEM toner.

Are you sure that you are using OEM Toner?

[mido]

I have a similar problem before. I just changed my generic toner to a OEM toner.

Are you sure that you are using OEM Toner?

thank you my friend

yes I am sure using OEM toner,

[Luther]

Make sure the right door when closed is applying pressure to the fixing unit