imageRUNNER ADVANCE 8000 / 6000 / 4000 / C2000 Series / All--E748-2012 Error Code

[teckat]

Publication describes the revised procedure to resolve E748-2012 error codes for the
imageRUNNER ADVANCE 8000 / 6000 / 4000 / C2000 Series.

Remedy change for an E748-2010 error code.
An E748-2010 error code is defined as a FLASH PCB error
in the Service Manual. An E748-2010 error code can also occur due to a HDD failure in the products series shown below. Therefore, the descriptions of an E748-20120 error code details and remedy has been
changed for the following target product series:
imageRUNNER ADVANCE 8105 / 8095 / 8085 Series
imageRUNNER ADVANCE 6075 / 6065 / 6055 Series
imageRUNNER ADVANCE 4051/4045/4035/4025 Series
imageRUNNER ADVANCE C2030/C2025/C2020 Series

see pdf----------E748-2012 Error Code.pdf

[Machie]

How are you Teckat? I just had the same error in Canon iR Adv C5255 after formatting and updating the system firmware but unfortunately it was not successful. What I did is replacing a working HDD from other same model and that is when the error occurred. I would be most grateful if you could tell me if I done something wrong? Thank you so much.

[teckat]

How are you Teckat? I just had the same error in Canon iR Adv C5255 after formatting and updating the system firmware but unfortunately it was not successful. What I did is replacing a working HDD from other same model and that is when the error occurred. I would be most grateful if you could tell me if I done something wrong? Thank you so much.

Never swap
Did u read pdf, open attached.

https://www.dropbox.com/home?preview...Error+Code.pdf