I have replaced the fuser film and presssure roller and error occurs occasionally. I have tested fuser motor and it works properly. Any advice and next step.
Thanks
I have replaced the fuser film and presssure roller and error occurs occasionally. I have tested fuser motor and it works properly. Any advice and next step.
Thanks
did you replace thermistor/stats?
did you replace any bushings/bearings?
did you buy parts a reputable source?
did you follow the service manual on rebuild?
did you reset any code/part life after rebuild?
you really don't give any help to us with such a brief explanation of the repair.
PhilB. "The Dentist"
did you replace thermistor/stats?
No I did not replace any thermistor
did you replace any bushings/bearings?
yes replaced bushings
did you buy parts a reputable source?
yes, items were purchased from reputable source. purchased same items from source before
did you follow the service manual on rebuild?
yes follow step by step rebuild procedure
did you reset any code/part life after rebuild?
I reset code, but did not reset count.
You post would be seen by a lot more qualified Canon tech if you placed in the actual Canon forum. https://www.copytechnet.com/forums/canon/
Bookmarks