Need technicians help to connect external device to defirents copiers

[mkdirs]

Hello guys
i develop an external device PayStation unit to manage copiers
i am a Xerox technician so i know how and where to connect my

external

device.

it's a standard protocol (I/O) for all copiers

i need help from other brands technicians like KYOCERA and Ricoh and MINOLTA.
to help me Ex. where the plug located for the uber brandes and how to configure in the machine (Like Key Counter) or External Device Unit
i test the device with old ricoh copiers 2205 the device work fantastic
also i test it with B&W AND Color Xerox copiers and its work fine
in new ricoh copiers like mp3352 i cannot fined the connector

right now i have kyocera 5501i for test any kyocera tech can help to give me an instruction how and where the key counter located and how to confgure it !!
also

MINOLTA and other brands !!

for more information i upload to youtube how the device work

YouTube

thanks all

[bsm2]

Older Kyocera use a wired plug to connect.New machine it plugs direct to main pcb.
Your 5501i will need a connect plug.
You have to turn on key counter in maintenance mode thats the same on all models.
Older models the connection jumper plug is usally on the side near the rear of machine.
If need you can pm me for the correct sim mode

[mkdirs]

thanks to

bsm2
he give me the Kyocera answer

konica Minolta techs !!! any one here ???
and what about recoh !!!

[Synthohol]

the 4 wire "molex" connector is behind the grill above the RS door on konicas.
the newer series also offer a connector on the PRCB for other types of payment solution hardware.
they both use different selections in vendor mode. trial and error unless your hardware specifies which one to use.

[copier tech]

Hello guys
i develop an external device PayStation unit to manage copiers
i am a Xerox technician so i know how and where to connect my

external

device.

it's a standard protocol (I/O) for all copiers

i need help from other brands technicians like KYOCERA and Ricoh and MINOLTA.
to help me Ex. where the plug located for the uber brandes and how to configure in the machine (Like Key Counter) or External Device Unit
i test the device with old ricoh copiers 2205 the device work fantastic
also i test it with B&W AND Color Xerox copiers and its work fine
in new ricoh copiers like mp3352 i cannot fined the connector

right now i have kyocera 5501i for test any kyocera tech can help to give me an instruction how and where the key counter located and how to confgure it !!
also

MINOLTA and other brands !!

for more information i upload to youtube how the device work

YouTube

thanks all

For Ricoh you need an optional board see attached this is for the MP 3352

Optional Counter Interface type A.pdf