Installed a new replacement waste toner container but the message will not clear and machine will not go to a ready state. Any ideas?
Installed a new replacement waste toner container but the message will not clear and machine will not go to a ready state. Any ideas?
I think I remember reading something about this issue on here or hearing it from Kyocera. It said something about opening and closing either the front door or the back cover to clear this warning. I could be wrong, but it's worth a shot. Good luck!
I am going by memory on this since I haven't worked for a kyo dealer for a year now. It is likely the photo interrupt that looks through the top of the waste container. If memory serves, I had customers empty the wtb and a dusty toner remained by neck blocking the sensor. In your case though it is a new wtb. It seems to me also that there was an issue with ambient light filtering through the door housing the wtb. If I recall we had one that would always show wtb full around noon when the sun peered through the window onto the copier. Try taking some copier paper and hold it to the door to block light just for a test. If I recall right, there was a door update to block ambient light.
I've proved mathematics wrong. 1 + 1 doesn't always equal 2.........
Especially when it comes to sex
The machine checks the neck of the toner bottle via LED to check if the waste toner is full. If the bottle neck is soiled with toner or the sensor/LED that looks through the neck is dusty the 'replace waste bottle' message wont clear.
Use an can of air etc to blow/clean in the are marked in this picture.
maxresdefault.jpg
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Look at the picture. You should be able to clean led with qtip. It's right there when you open door. The transmitter looks to receiver front to rear at top of bottle. By looking in with the picture it would be left to right at top of bottle. Go into diagnostics and check sensor state, block it and check again. Reseat connections etc. The new waste containers are oem correct?
I've proved mathematics wrong. 1 + 1 doesn't always equal 2.........
Especially when it comes to sex
Bookmarks