My Kyocera KM-3060 has so many annoying dots when photocopying or printing. i have attached a test page. Help me fix this.
My Kyocera KM-3060 has so many annoying dots when photocopying or printing. i have attached a test page. Help me fix this.
the fix for this is due to the age of the copier buy a new one.... put this one in a museum.
Something is arcing to the drum. A drum and developing unit will fix this ... if you can find them. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Since the spot pattern is not repeated at an interval equal to the circumference of the drum, the drum might still be good. Most likely the developer is either contaminated or not genuine Kyo. Have the developer replaced before it destroys the drum.
Hi
I look your print sample. You don't have problem with OPC or DEV. The problem is gap between DEV roller and OPC. Something did not sit well. The magnetic roller is too close to OPC. Maybe you have toner build up on dev section and OPC will pick that toner and make that on print page. Most likely. You can start from there.
Last edited by Drivee; 09-15-2021 at 07:08 AM. Reason: new idea!
Is this the status page of this copier?
if so once you get problem fixed charge grid ? etc.
looks like time to intialize hdd and machine .
265 /to a --2
252/ inch
Bookmarks