LJ 400Pro 49k OEM drums.
Thought someone may have run across this annoying issue.
After a print has completed its run a noise is prevalent.
Now the machine has stopped running, meaning drums, transfer, laser and fuser have finished
their cycle. Only item running I can figure out is fan on right side and this is quite. Still there is this
intermit almost like two rubber rollers pressing against each other.
This noise reminds me of a feed roller noise on the LJ4000 series.
Seems to get louder but at 5 seconds its hard to pin point.
This is a royal pain in the axx.

My best THANKS to someone who has a solution.


"When I was a Lad, the Dead Sea was only sick"