I have one in my future ...
I've done the swing plate on the 2430, the 4100, and the 4345. It isn't too bad, is it?
=^..^=
I have one in my future ...
I've done the swing plate on the 2430, the 4100, and the 4345. It isn't too bad, is it?
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
if you've done a 4345 this is much easier. The only thing I hate is removing that plate above the transport section to get to the one screw on the swing plate. Have a little stubby screw driver in your case for those two screws. All the 4200 4300 600 series are basically the same routine. Good luck
its not too bad. first time will take you prolly 1 to 2 hours. ive done 4 so far and it gets easier. hp-p4015-m600-series-grinding-from-fuser.pdf
Bookmarks