Results 1 to 3 of 3
  1. #1
    Trusted Tech 50+ Posts
    Join Date
    Jun 2017
    Location
    Columbia
    Posts
    87
    Rep Power
    7

    L26500 (Latex 260) after replacing the belt get 79:04

    After replacing the belt on an L26500 (Latex 260) I get 79:04 right before it gets ready to print a test print. I think there MAY be a printhead problem that is the source, but not sure.

    I noticed in one post Kiran states to reseat cartridges, printheads, and RAM. I will try to pull cartridges and printheads and insert them as prompted, and clean printhead contacts. I cleaned carriage contacts before reinstalling printheads after belt replacement.


    Interesting: It will print the simpler "test plot" but NOT the "advanced test plot". That makes me think it is a printhead. But I don't know.



    Initially on the advanced test plot it would slam the right side and throw up 79:04. I recovered the hard drive and now it ONLY throws up 79:04 without slamming. Not sure there is a relationship. I also tried to reconnect the carriage. Again I think it stopped slamming the right side after the HD recovery.



    The specifics are:
    File: /vots/patum/gg/TARGETS/mv140-x86-opt/elektra/penink/pen/Pen/Godzilla/PenDigitalManager.cpp
    Line: 1118
    Class: software
    subclass: assert
    error: assertion
    define: assert_error
    description: assertion: "temp_per > maxim"



    Obviously, I only disconnected and reconnected the carriage.


    And removed and replaced the printheads. They of course sat out a little while.


    I am a bit curious about the encoder strip. There appears to be a tiny black mark on it; don't know that that is of any consequence. I assume it was there before or maybe I got it on there via handling.


    Thanks for any insight.

    Paul
    Last edited by pbrooks259; 4 Weeks Ago at 04:58 PM.

  2. #2
    Field Supervisor 500+ Posts
    L26500 (Latex 260) after replacing the belt get 79:04

    Kiran Otter's Avatar
    Join Date
    Dec 2013
    Posts
    717
    Rep Power
    26

    Re: L26500 (Latex 260) after replacing the belt get 79:04

    The error certainly seems to talk about the 'pens' (printheads) so yeah, I'd say you have a bad printhead somewhere. Maybe swap them with their sisters and see if something changes.

    Kiran

  3. #3
    Trusted Tech 50+ Posts
    Join Date
    Jun 2017
    Location
    Columbia
    Posts
    87
    Rep Power
    7

    Re: L26500 (Latex 260) after replacing the belt get 79:04

    Thanks for your reply.

    I think I resolved it by the ol' remove all consumables--ink, printheads, and media--and reinsert them as requested by the printer. None were rejected upon reinsertion. Perhaps one was not making good contact. I don't really know.


    Also, I cleaned the printhead and carriage contacts.

    So far so good.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here