When copying off glass each successive copy out from , single scan to single page copy , the Lead edge increases about 1 mm . If I do a "Restore Defaults" and make copies , the 1st page out looks fine and each successive page , single scan to single page copy , same problem . All print and internal pages seem fine no matter how many I run . If I make copies using the ADF , they seem stable . Tried adjusting the Alignment , this did not help . My parts supplier suggested that it is a scanner problem , but the customer does not want to spend more money as we just recently replaced the fuser as per their request , getting more expensive than they want to spend . Thanks in advance as always , Ark .
Bookmarks