I ordered a few duplex assemblies. Let's see how that goes.
You can modify a duplex assembly for simplex. We've done it. Just removing two gears and the belt.
I ordered a few duplex assemblies. Let's see how that goes.
You can modify a duplex assembly for simplex. We've done it. Just removing two gears and the belt.
The duplex fuser drive assemblies are still available. Modding duplex to make simplex it is!
Will do. Stay tuned.
Hey, I wanted to thank all the contributors in this thread. Had a cp3525 with said error and was able to repair/modify the sticky solenoid to resolve the issue.. It's alive and well now. Thanks!
Im gonna pull the fuser assembly and double check to make sure my gears are not out of time like the ones shown on this page: HP CP3525 - 59.F0
Just do what Phil B said. If you didn't pull out the freezer drive assembly do not touch it. I really think Phil B is correct in saying that you probably inserted the solenoid back incorrectly.
But just to make sure there is a component test in this printer that allows you to test ITB alienation. You should be able to hear solenoid clicking normally.
Good luck.
Note**
Do not remove the main drive. I know the engineering manual says to do so but don't. You will save yourself a lot of drama.
Sent from my GM1917 using Tapatalk
Bookmarks