Greetings from Argentina. I have the same oor simiar problem. Any suggestions?
I´m looking for help solving a touchpad calibration issue on Bizhub.
We were doing a maintenance procedure. We accessed touchscreen calibration option.
We made a mistake during process:
We pressed the calibration points that appear on screen during the calibration procedure in a wrong way (We clicked over the “arrows” instead of clicking over the “crosses” in the screen corners).
After touching on the wrong places... we confirmed the calibration
.
It was working perfectly before, after wrong calibration we made, touch screen is totally miss calibrated.
We can't go back to the calibration option to re calibrate it.
If we repeat all steps to enter calibration screen, we get sucked on the last step, as follows:
We press micro switch to reset. When dots [.] shows up at the center on the left-hand side of the screen, we enter [3] from the 10-Key Pad. We enter the 8-digit service code [00000000]. But we cannot touch [END] button, as the screen is miss calibrated.
Is there any option to enter screen calibration without touching touch screen? Thank you very much
Bookmarks