I try removing and fitting the riser but nothing change.
Attach is what appears in the panel
Thanks in advance for your assistance
Sent from my HUAWEI RIO-L01 using Tapatalk
I try removing and fitting the riser but nothing change.
Attach is what appears in the panel
Thanks in advance for your assistance
Sent from my HUAWEI RIO-L01 using Tapatalk
It might be pertinent to know what model that you're considering.
But just on the most basic level, there isn't any power to one of the power plugs. Find out why. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
i take it this is not a U.S. machine? there is only a single 20A plug on the U.S. models.
To be more specific it's a bizhub 654 .The machine has only done a 105 prints it was working well but as been not in use and switched off for some months and recently I try switching it on and it came up with the error "Fusing plug missing"
Sent from my HUAWEI RIO-L01 using Tapatalk
Hi, Has anyone solved this? Ran into same problem today. Cant find any Information regarding it. Thanks
I am having the same problem after doing an all clear for a c163. My take on it would be that the machine is confused and thinks its a model with a separate fuser plug.
I figure a good place to start would be to set the correct time and time zone. This machine will only show tab number 8 Device information so not able to put correct time.
what I ended up doing was turning off smart fusing control under system 2 in service mode.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
Bookmarks