[QUOTE = Zesti; 585604] 얘들 아, 무엇을 말해. BH363을 가지고 있는데, 기술자가 암호를 지우려고했습니다. 그는 NVRAM을 엉망으로 만들었습니다. 제가 고칠 때, 카운터는 0000000이었습니다.
[/ QUOTE]
How to make BIZHUB C364 total counter "0"
1. Power ON (next when booting is completed)
2. MENU ⏎
3. Counters
4. Enter into service mode (Stop +00+ Stop + 01 + 9272927292729272 + OK)
5. System setting 1 ⏎
6. Initialization
7. Delete individual data of data deletion Click all + OK
(Caution: Please backup your fax setup data and address registration data in advance.)
8. Enter serial number
(If you want to keep the body serial number, write down all of them.)
9. Press OK to return to service mode.
10. System Settings 2 ⏎
11. Software SW Setting
12. Switch number
13. If "10" is set to "02" in the input HEX designation, press "C" to make it "00", then press Confirm.
Press switch number again and press 25 to display 60 in HEX designation.
(The HEX number may vary depending on the model.)
Take note of this part. Press OK to exit from service mode.
14. Turn off the power and open the rear panel and use the tweezers enclosed with the battery of the main board to let it bounce for about 2 minutes.
15. Plug the included "USB1" into the rear USB service port on the right side of the copier.
16. Power ON
17. Wait about 30 seconds and the boot screen will appear asking you to enter the serial number.
18. Power off
19. Plug the supplied "USB2" into the rear USB service port on the right side of the copier.
20. Power ON
21. If you wait about 10 ~ 20 seconds, you will see "C"
Button.
22. Press the YES button on NVram in the Clear Seleat section. ⏎
23. START ⏎
24. When Completed is displayed, turn off the power.
25. Remove the USB cable on the back and turn the power on (remove the USB cable,
Screw down)
26. I get a message asking to insert the serial number.
27. Enter the serial number and recovery license code you received when the serial number message appears.
(Menu + Counter + Stop + 00 + Stop + 01 + 9272927292729272 + OK + System setting 1+ Marketing area + Others2 + Fax sending part set to KR + OK + Serial number input + Print + Serial number input + OK + System setting 2 + Software SW setting + Switch number + 10 + HEX designation + ⇨ + 02 + Confirm + Switch number + C + 25 + HEX designation +60 + Confirmation + OK + Firmware version display + OK + Stop + 9 + License management + Restore + Restore Enter Code + Confirm + Power OFF / ON)
28. Menu + User Settings + System Settings + Language Selection + Korean + OK
29. Enter the service mode, set up the hard and fax in System Setting 2, and enter the service mode when prompted to insert animation data.
30. Optional - You do not need to do this.
The serial numbers that you noted in step 8 are the serial numbers
Clear the entry and enter the serial number of the print, scanner, or ADF you wrote down.
Bookmarks