Fiery showing FF on c6500 ic408

[Synthohol]

I have for the ic408 versions 1.1 and 2.0
Do not try 2.0 unless you have had the bios and ram upgrade already installed.
Just 1 contributor badge away from getting that fiery up and running

[Copy Bargain]

Thanks guys! I'm happy to contribute! Now how do I go about reloading the software on the the "Bolt-On" IC-408 Fiery server??

Best,

Romeo

[Copy Bargain]

I have for the ic408 versions 1.1 and 2.0
Do not try 2.0 unless you have had the bios and ram upgrade already installed.
Just 1 contributor badge away from getting that fiery up and running

Currently, my Server Info is:

Password Enabled: Yes
Memory (MB): 1024
Software: EFI Fiery System 8 Release 2
Version: 2.0
Disk Size (MB): 60016
Free Disk Space (MB): 51937

[Synthohol]

I sent you a link to the system ver 2.0

Enjoy

And a 2nd pm for the instructions.

Thank you very much for contributing!!!

[Copy Bargain]

I sent you a link to the system ver 2.0

Enjoy

And a 2nd pm for the instructions.

Thank you very much for contributing!!!

Thanks Synthohol! I didn't even need to restore the software! When reading the instructions, I ran across the section for printing out the configuration settings to prepare for the reconfiguration, and out of curiosity I started comparing the settings from now to 3 years ago and noticed that the darn network Ethernet speed was incorrect!!

It's been 5 months holding off and thinking my Fiery went bad! What a relief!!

Thank you so much though! You still helped lead me into a solution, and I still have the software JUST IN CASE!

[mariuscmr]

I'm also interested in the software image after a HDD crash. I managed to clone the OS and Backup partition, but the one labeled "Fiery" has got a lot of bad sectors and unreadable files. It's for Fiery X3eTY2-10. Can I get it, please, if I also contribute?

Thank you!

[Synthohol]

I have for the ic408 versions 1.1 and 2.0
Do not try 2.0 unless you have had the bios and ram upgrade already installed.
Just 1 contributor badge away from getting that fiery up and running

Still applies.

[Walterj]

Looks like I need a hard drive or Reload the software and my tech is 3 days out.

I am looking to operate the printer without the controller , direct from server or PC.

Is that possible? I am being told yes and No.

I have gone into the dip switches DIPSW 2-1 (1) On

Set my NIC Ip to a range that is will pick up.

Connected to the appropriate LAN on the machine.

Is it futile? Can you only print via a controller?

good day
The error presented by your fiery must be due to the defective HDD, I recommend you replace it and load the operating system.
You can write to me at walvaradocruz@gmail.com
Greetings.

[Synthohol]

you are responding to a user's post from 3 years ago.
please check the date of posting if you are quoting someone.