Scanner Position Tool

[blazebusiness]

The tool is used for when you are moving the machine to another location to prevent damage to the scanner unit. Well that's what we were told on the remote training

No, that's not right. The scanner locking hardware (screws) are what stop the scanner from moving during transport. The adjustment tool, though rarely needed, is for evenly adjusting scanner position so the scanned image isn't skewed or distorted.

For an illustration of that ----See page F-5 in the manual for locking down the scanner

bizhub C360i/C300i/C250i F DISASSEMBLY/REASSEMBLY > 4. Notes when transporting the machine

[copyrooks]

No, that's not right. The scanner locking hardware (screws) are what stop the scanner from moving during transport. The adjustment tool, though rarely needed, is for evenly adjusting scanner position so the scanned image isn't skewed or distorted.

For an illustration of that ----See page F-5 in the manual for locking down the scanner

bizhub C360i/C300i/C250i F DISASSEMBLY/REASSEMBLY > 4. Notes when transporting the machine

My bad you're right, i mixed up this with the move scanner to home setting in service mode.

[rrrohan]

There are mechanical scanner and PH skew adjustments on i-series. But this Jig is only mentioned in Service tools, I hope we never need it but it's there.
I could imagine if one purchase it will come with detailed instructions how to use it.

I will let you know if it comes with any documentation

[rrrohan]

so this thing is expensive for what it is

here is a picture

scan 1.jpgscan 2.jpg

but no documentation. i think you just connect it ontop of scanner and move it to the edge (presume left side) and make the adjustment to the wire behind left cover of scanner