I need to NVRAM reset tool bizhub C280

[mhmds102466]

you have been given the install info time n time n time again.

IF you need a "video" to get you thru it .. you are not a tech.

why the hell can't you just follow the MANUAL like everyone else does?

I followed the entire preparation steps and did not solve the problem I know that I am not technical
But the video file will help

[mhmds102466]

I went to the bizhub machinery maintenance center
I explained to them the problem, and I had a technical office requesting $ 400
To solve the problem is it reasonable to solve the problem the cost of all these amounts and I have a machine number
And the amount is too exaggerated
I ask the artists of the forum to make a video to solve the problem and I apply the steps and thank you
I know I'm annoying to you, but I want to help because the machine doesn't work
Thanks

[Phil B.]

I went to the bizhub machinery maintenance center
I explained to them the problem, and I had a technical office requesting $ 400
To solve the problem is it reasonable to solve the problem the cost of all these amounts and I have a machine number
And the amount is too exaggerated
I ask the artists of the forum to make a video to solve the problem and I apply the steps and thank you
I know I'm annoying to you, but I want to help because the machine doesn't work
Thanks

OH another brokedick end user determining HOW MUCH technical help is worth...

lemme pose this question...

with all the PROPER instruction you have received here FOR FREE, how much value ($$) do you place on help? Plenty as long as it's FREE!

you were told from the gitgo how to fix it but you SHOULD hire a qualified tech. We have dicked with you for 3 months... you get it right.. then change something and we're back to square one over n over..

I'm done and I think we should STOP trying to help someone that CLEARLY isn't capable of following WRITTEN STEP BY STEP instructions... (I wish we had a middle finger emoji ... so I could tell you to FUCK OFF!)

[mhmds102466]

Thank you for your attention
thank you all
I solved the problem of the c284e machine
And the rest I have c280
Because I cleared all the evidence and started the numbers from scratch
The result is positive and the lines have gone forever
Thanks a lot
Thank you words are not enough thank you all